Flooring should be one of the last items installed in any new construction or remodel project.

Handle with care in the process of transportation and handling to avoid damage to the locking of flooring.Please put it on the flat ground, no erect or sideways.

All “wet” work such as paint, drywall, concrete, masonry, plumbing must be complete and dry prior to thedelivery of SPC flooring. Gutters and downspouts should be in place and the exterior grade complete to allow forproper drainage of water away from the building’s exterior perimeter.

Inspect all materials carefully for color, finish, sheen and defects before installation. Ensure adequate lighting for proper inspection. The warranty does not cover materials with visible defects once they are installed. If there are any doubts to the quality, dimensions or appearance of the SPC flooring, DO NOT INSTALL. Please contact ASCXN Flooring as INSTALLATION IS ACCEPTANCE.

Install flooring on flat, clean and moisture-free ground. The height difference tolerance is no more than ±1mm. It is recommended to make ground leveling or self-leveling first.

Do not install SPC flooring in places under direct sunlight to minimize thermal degradation, color fading, and potential adverse effects. If installed in a room with glass windows, it’s required to install additional curtains to prevent the floor from being exposed to direct sunlight.

Leave about 5-8mm expansion joints between the wall and the flooring when installing the floor.

Use accessories to separate the flooring of different rooms, as their usages and temperatures are different.

It is advised to use the built-in 1mm-1.5mm underlayment. Do not use floor mats or other materials.

If the area exceeds 300 square meters and the length or width exceeds 15 meters, please use the floor partition and expansion joints. The long side of the plank should be installed perpendicularly to the short side of the room; in order to enhance air ventilation below the planks.

In the process of installation, the lock button can be gently buckled in place. Do not use tools or heavy objects to knock the lock button, so as to avoid over-tight floor installation and locking damage. We advise you to use a rubber hammer for installation. During installation, engaging the next plank at a 30 degree angle to the front plank. Use a rubber hammer to lightly tap the locking system, making sure that they are tight before sliding and securing in place. This step is to avoid breaking the below locking system.

Install SPC flooring from several boxes at one time to ensure a good color and shade mix.

When purchasing flooring, we recommend adding 5%-15% to actual square footage needed for cutting allowance and to compensate for culled material.​